bioRxiv Science⌕ Search
Home/Archive/bioRxiv

bioRxiv · 10.1101/2020.03.19.998757

An Experimental Validation of the Computer Fluid Dynamics of Normal Human Nasal Airflow Using a Precise 3-D Printing Model

Fu, X.·Cheng, Y.·Liu, H.·Liao, J.·Kou, M.·Shen, C.·Ge, Q.·Yan, S.·Peng, H.
View original source ↗Export metadata ↓

Abstract

Computer Fluid Dynamics (CFD) is a popular method for studying airflow of nasal cavities. However, the data of CFD studies has rarely been validated through experiments. To test the accuracy of CFD computation, we studied the consistency of the air pressure of nasal cavities in the CFD and the experiment. A proportional resin model of a normal human subjects nasal cavities was created by a 3-d printer with a precision value of 0.1mm. The pressure of 63 check points in the nasal cavities in different breathing states was measured. The experimental data was compared with the data obtained by CFD simulation. At the flow rates of 180 ml s-1 and 560 ml s-1, the pressure in all check points remained highly consistent with the CFD data. At 1100 ml s-1 flow rate, there was a significant deviation in the posterior segment of the nasal cavity during exhalation. The method used in this study to measure the pressure in the nasal cavities can be used in experimental validation of CFD data. The computational methods and the boundary conditions used in this study resulted in a high agreement between the results of the CFD simulation and the experiment. Author SummaryIn the contemporary era, Computer fluid dynamics (CFD) is the mainstream method for studying air flow. Due to the complex anatomical structure of the nasal cavity, the CFD results of the nasal flow have rarely been experimentally verified. This study provides a method to verify the methods and results of nasal CFD. We printed an accurate model of a normal persons nasal cavity with a high-precision 3D printer. In this nasal cavity model, we set 63 small holes to detect the air pressure of the places we concerned. Three different nasal flow quantity are used to represent different breathing conditions: high (1100 ml s-1), medium (560 ml s-1), and low (180 ml s-1). In medium and low nasal flow quantities, our CFD results are in good agreement with the experimental pressure values. On this basis, we analyzed the characteristics of nasal airflow in normal people. The method used in this study to measure the pressure in the nasal cavities can be used in experimental measurements of the partial resistance of the nasal cavity. With proper modification, it can be applied to the clinical practice for nasal resistance, giving more help for the design of the operation plan.

Explore related subjects

biophysicsPreprint

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Fu, X., Cheng, Y., Liu, H., Liao, J., Kou, M., Shen, C., Ge, Q., Yan, S., Peng, H.. 2020-03-19. An Experimental Validation of the Computer Fluid Dynamics of Normal Human Nasal Airflow Using a Precise 3-D Printing Model. https://doi.org/10.1101/2020.03.19.998757

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related preprints

bioRxiv2026

Semidilute Polymer Scaling Controls PEG-induced Protein Phase Separation

When does polyethylene glycol (PEG) mass concentration provide a common measure of crowding strength across polymer chain lengths? Here we use bovine serum albumin (BSA) and PEG as a controlled depletion system and measure both coexisting phases to determine binodals, tie lines, and critical points across PEG molecular weights of 4--100 kDa. Phase diagrams for PEG 20, 35, and 100 kDa approximately collapse in mass-concentration coordinates, consistent with semidilute polymer scaling. Generalized free volume theory (GFVT) describes the BSA binodals and tie lines. It also approximately describes binodals for three additional globular proteins in PEG 35K, extending the comparison across proteins spanning 7.2--66.4 kDa. For the binary PEG mixtures tested, GFVT approximates the binodals using an effective polymer size corresponding to the weight-average molecular weight. These results identify a regime in which PEG mass concentration (g/L) provides a transferable measure of depletion-induced crowding.

biophysics↗
bioRxiv2026

Correlation-resolved sum-frequency generation microscopy of biological tissue with bright twin beams

Sum-frequency generation (SFG) driven by bright twin beams generated through high-gain parametric down-conversion comprises a coherent component arising from correlated mode pairs and an incoherent component arising from interactions between uncorrelated modes. Modal correlations can enhance coherent SFG in anisotropic nonlinear media, for example by extending the effective interaction length. Whether such correlations can likewise benefit image formation in heterogeneous biological tissue remains unknown. Here we address this question by performing SFG imaging of biological tissue using bright twin beams as the excitation source. Spectral decomposition of the SFG signal separates its coherent and incoherent components, allowing us to reconstruct co-registered images and examine how twin-beam correlations influence image formation. In mouse skeletal muscle, the coherent-component image revealed sarcomere periodicity with a Bragg-spot-to-background ratio of approximately 310, compared with 7.5 in the incoherent-component image. In fresh human dermis, the coherent-component image showed greater Fourier power than the incoherent-component image in the 0.30-0.50 \mu m^{-1} band and a greater fractional autocovariance decay at short spatial lags. These results demonstrate that twin-beam correlations can enhance contrast and detectability at selected spatial frequencies in heterogeneous tissue. Correlation-resolved SFG microscopy thus offers a route for exploiting bright quantum-light sources in nonlinear optical bioimaging.

biophysics↗
bioRxiv2026

Polarization affects viscoelasticity and podosome distribution of primary human macrophages

Macrophages are essential cells of the innate immune system that regulate wound healing and tissue homeostasis. They exert diverse functions, depending on their polarization state, which can lead to either functional healing of the tissue or fibrosis. Macrophage polarization state is affected by both the local biochemical and mechanical microenvironment within the tissue, suggesting a possible dependence of macrophage function on cell mechanical state, which has been poorly explored to date. In this study, we provide a systematic and quantitative characterization of the viscoelastic properties of unstimulated, pro-inflammatory, and anti-inflammatory monocyte-derived primary human macrophages at the single-cell level using atomic force microscopy. Pro-inflammatory macrophages exhibited a lower elastic modulus (E = 458.8 {+/-} 179.9 Pa) and a more dissipative response (low frequency exponent = 0.22 {+/-} 0.03) than anti-inflammatory macrophages (E = 716 {+/-} 345.6 Pa and = 0.15 {+/-} 0.04). These differences in mechanical properties were independent of cell morphology but correlated with differences in podosome distribution with pro-inflammatory macrophages exhibiting a dispersed distribution, and anti-inflammatory macrophages a more clustered distribution. This study identifies polarization-dependent mechanical differences in human primary macrophages and provides a quantitative experimental framework for future work in macrophage mechanobiology.

biophysics↗