Decision-making in serial crystallography: a simple test to quickly determine whether sufficient data have been collected
In standard rotational data collection for macromolecular crystallography data are normally collected from a single crystal, and the resulting data processing delivers metrics for data completeness and signal to noise that are well established. However, in serial crystallography it can be difficult to assess quickly whether enough data have been recorded to deliver a well scaled and complete dataset with sufficient signal to noise to address the scientific question being asked. Completeness alone is not an appropriate metric, as a nominally complete dataset can be obtained with a much smaller number of images, and thus multiplicity, than is needed to produce a final dataset with well estimated merged intensity values. Insufficient data result in alarmingly reasonable processing statistics and plausible electron density maps that contain almost no experimental signal, instead being dominated by the phases from the phasing model. We have therefore established a simple electron density-based test to determine whether enough data have been collected, and implemented this in the autoprocessing pipeline at the T-REXX endstation on beamline P14 at PETRA III. Importantly, the results of this test help guide decisions as to whether more data should be collected, or whether the experimenter can move onto a new time-point or sample. SynopsisWe describe a simple test to determine whether sufficient data have been collected during a serial crystallographic experiment, and its incorporation into the autoprocessing pipeline at the T- REXX endstation on beamline P14 at the PETRA III synchrotron.