bioRxiv Science⌕ Search

bioRxiv · 10.1101/184044

Temporally-Feathered Intensity Modulated Radiation Therapy: A technique to reduce normal tissue toxicity

Abstract

PurposeIntensity modulated radiation therapy (IMRT) has allowed optimization of three-dimensional spatial radiation dose distributions permitting target coverage while reducing normal tissue toxicity. However, radiation-induced normal tissue toxicity is a major contributor to patients quality of life and often a dose-limiting factor in the definitive treatment of cancer with radiation therapy. We propose the next logical step in the evolution of IMRT using canonical radiobiological principles, optimizing the temporal dimension through which radiation therapy is delivered to further reduce radiation-induced toxicity by increased time for normal tissue recovery. We term this novel treatment planning strategy \"temporally feathered radiotherapy\" (TFRT).\n\nMethodsTFRT plans were generated as a composite of five simulated treatment plans each with altered constraints on particular hypothetical organs at risk (OARs) to be delivered sequentially. For each of these TFRT plans, OARs chosen for feathering receive higher doses while the remaining OARs receive lower doses than the standard fractional dose delivered in a conventional fractionated IMRT plan. Each TFRT plan is delivered a specific weekday, which in effect leads to a higher dose once weekly followed by four lower fractional doses to each temporally feathered OAR. We compared normal tissue toxicity between TFRT and conventional fractionated IMRT plans by using a dynamical mathematical model to describe radiation-induced tissue damage and repair over time.\n\nResultsModel-based simulations of TFRT demonstrated potential for reduced normal tissue toxicity compared to conventionally planned IMRT. The sequencing of high and low fractional doses delivered to OARs by TFRT plans suggested increased normal tissue recovery, and hence less overall radiation-induced toxicity, despite higher total doses delivered to OARs compared to conventional fractionated IMRT plans. The magnitude of toxicity reduction by TFRT planning was found to depend on the corresponding standard fractional dose of IMRT and organ-specific recovery rate of sublethal radiation-induced damage.\n\nConclusionsTFRT is a novel technique for treatment planning and optimization of therapeutic radiotherapy that considers the non-linear aspects of tissue repair to optimize toxicity profiles. Model-based simulations of TFRT to carefully conceptualized clinical cases have demonstrated potential for normal tissue toxicity reduction in a previously described dynamical model of normal tissue complication probability (NTCP).

Source connections

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Alfonso, J. C. L., Parsai, S., Joshi, N., Godley, A., Koyfman, S. A., Caudell, J. J., Fuller, C. D., Enderling, H., Scott, J.. 2017-09-03. Temporally-Feathered Intensity Modulated Radiation Therapy: A technique to reduce normal tissue toxicity. https://doi.org/10.1101/184044

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related preprints

Single Molecule Diffusion Studies Reveal Rapid Translations Across Target Membrane Surfaces for both p40Phox PX domain and Class III PI3K VPS34 Complex 1, the Autophagy Lipid Kinase

Single molecule analyses are providing new insights into the molecular mechanisms by which peripheral membrane proteins approach and translate across a target bilayer surface before stable docking. Here we compare and contrast the translational movements of four diffusers on a representative supported lipid bilayer: (i) the fluorescent lipid LRB-(DO)PE, (ii) the G-protein Rab1A anchored to (DO)PE; (iii) the PI(3)P sensor p40Phox PX domain, and (iv) the autophagy lipid kinase VPS34 Complex 1. The latter enzyme is a Class III PI-3-Kinase and its unusual architecture exhibits two distinct membrane-docking "feet" unique to Class III PI3Ks. Notably, the membrane contact surfaces of the PX domain and autophagy lipid kinase each possess multiple positive charges suitable for electrostatic interactions with their anionic target membrane. The present single molecule tracking studies reveal that both the fluorescent lipid and the lipid-anchored G protein Rab1A exhibit 2-dimensional translation typical of simple lipid diffusion in the bilayer. Single molecule density measurements indicate both PX domain and autophagy lipid kinase exhibit significantly reduced membrane docking when the bilayer negative charge is decreased, confirming the importance of their protein-bilayer electrostatic interactions. Single molecule tracking studies reveal that both PX domain and autophagy lipid kinase exhibit hopping movements across the bilayer surface during their initial bilayer contacts, yielding a significantly higher frequency of long range displacements than allowed by lipid 2-D diffusion. After transitioning from hopping to a stable bilayer-docked state, both PX domain and autophagy lipid kinase exhibit 2-D diffusion slower than lipid diffusion indicating the appearance of increased frictional drag against the bilayer due to new protein-bilayer contacts. PX domain requires its target lipid for the transition from electrostatic hopping to stable bilayer docking, while autophagy lipid kinase can dock spontaneously to anionic lipid bilayers even in the absence of its substrate lipid. In principle, the slowly diffusing, bilayer-docked states of PX domain and autophagy lipid kinase could be interrupted by unbinding-hopping-rebinding events. However, such events are not detected for PX domain in the presence of target lipid (DO)PI(3)P nor for autophagy lipid kinase in the presence of substrate lipid (DO)PI. Instead, unbinding-hopping-rebinding events are only observed for autophagy lipid kinase in the absence of substrate lipid, indicating that the presence of a specific binding lipid reduces the frequency or spatial amplitude of such events. Overall, the findings provide evidence that p40Phox PX domain possesses a search mechanism involving electrostatic hopping that speeds its acquisition of target lipid, as previously observed for PH domains. The evidence indicates that the autophagy lipid kinase also exhibits electrostatic hopping/skating behavior that is proposed to play a functional role by speeding regulatory encounters with autophagy lipid kinase activators and effectors. Moreover, the ability of the lipid kinase to spontaneously dock to anionic membranes without a target lipid could facilitate its distribution across broad regions of the growing autophagosome. Finally, the autophagy lipid kinase exhibits multiple translational modes that we hypothesize are enabled by its two membrane docking feet.

biophysics↗

Inferring scaling laws of branching networks from their geometry by global optimization

Optimality principles are widely used to understand branching networks, yet they are tested on individual branchings that cannot reliably distinguish competing scaling laws. We formulate the missing link between the laws and measurements by mapping each law to its predicted branch points through global optimization. Vascular branch points closely match weighted-length optima when each vessel is allowed its own fitted weight. Inferred scaling laws reveal type-specific geometric signatures hidden from local analysis. They beat all tested laws, including Murray's law in 1,679 of 1,744 held-out hepatic and pulmonary trees. For coronary arteries on the heart surface, an exact discrete optimization model extends the framework beyond convex geometry and supports area-preserving scaling. The framework also identifies distinct laws for airways and plant shoots while rejecting weighted-length optimality for neuronal axons. Global optimization turns network geometry into a quantitative test of the principles that govern branching networks.

biophysics↗

Ultra-precision 3D Printed Sample Tubes of Complex Cross Section for Enhanced Electron Paramagnetic Resonance Sensitivity of AqueousSamples

This paper discusses the applications of ultra-precision 3D printing in developing EPR sample tubes for X-band measurements of aqueous samples. The seed idea of this work started from the flat cell idea discussed in Mett and Hyde et al.(2003), Sidabras et al. (2005), and Sidabras et al. (2017), where placing multiple aqueous flat cells perpendicular to the electric field in the microwave cavity reduce RF losses and improve EPR signal sensitivity. In this work, we present the 3D printed aquastar sample holders for dielectric resonators and the aquasun sample holders for cavity resonators. Even though the ultra-precision 3D printing enables the fabrication of complex cross-sections at 25um resolution, the photopolymer material has comparatively higher dielectric losses compared to the conventional materials like glass and PTFE. To reduce the RF losses due to the inherent dielectric properties, we introduced the latticing approach in reducing the amount of plastic without compromising the structural stability. In addition to this, we present the slicing and dielectric approximation approach in reducing the computation cost for these complex cross-sections. The novel sample tubes discussed here present signal improvements through both simulation and experiments, which were validated through power saturation experiments. The sample tube development methodology presented here provide a general framework for designing and implementing 3D printed EPR sample holders, based on resonator electromagnetic field distribution and dielectric properties of the photopolymer material.

biophysics↗