bioRxiv Science⌕ Search

Biology subjects

Walthaus, O. K.

Publications and source records attributed to Walthaus, O. K..

2 recordsLinked to original sources

The allometry of discontinuous gas exchange cycles in Atta cephalotes leaf-cutter ants

Many idle insects exhibit discontinuous gas exchange cycles (DCGs). During DCGs, CO2 is released in discrete bursts, followed by periods of negligible gas exchange. The standard metabolic rate (SMR) is thus determined to first order by the product between cycle frequency (fc) and burst volume (Vb, SMR {approx} fc{middle dot} Vb). The evolutionary allometry of these parameters is well studied, but it remains unclear if their static allometry, measured in individuals of the same species, sharing the same ontogenetic stage, follows the same patterns. To address this question, we investigate the static allometry of DCGs in Atta cephalotes leaf-cutter ants workers varying by two orders of magnitude in body mass. The SMR allometry significantly exceeded the standard prediction from the nutrient supply network model, and differed from the SMR allometry observed across insects. This disproportional increase was exclusively achieved by an increase in Vb, perhaps because fc is stabilised by neural and mechanical constraints. It may be necessitated by the positive allometry of the largest muscle in Atta--the mandible closer muscle--which increases with a virtually identical allometric coefficient, providing further evidence that the principles of symmorphosis may be upheld in insects.

physiology↗

Biomechanics of cutting: sharpness, wear sensitivity, and the scaling of cutting forces in leaf-cutter ant mandibles

Herbivores large and small need to mechanically process plant tissue. Their ability to do so is determined by two forces: the maximum force they can generate, and the minimum force required to fracture the plant tissue. The ratio of these forces determines the required relative mechanical effort; how this ratio varies with animal size is challenging to predict. We measured the forces required to cut thin polymer sheets with mandibles from leaf-cutter ant workers which vary by more than one order of magnitude in body mass. Cutting forces were independent of mandible size, but differed by a factor of two between pristine and worn mandibles. Mandibular wear is thus likely a more important determinant of cutting force than mandible size. We rationalise this finding with a biomechanical analysis which suggests that pristine mandibles are ideally sharp - cutting forces are close to a theoretical minimum, which is independent of tool size and shape, and instead solely depends on the geometric and mechanical properties of the cut tissue. The increase of cutting force due to mandibular wear may be particularly problematic for small ants, which generate lower absolute bite forces, and thus require a larger fraction of their maximum bite force to cut the same plant.

evolutionary biology↗